Remove left side panel cover by removing the side frame screw nut by using screw driver (In some of other make and model, this side panel also can be removed just pressing the looking clip)
After removing the screw nuts or unlocking the clips, press the side panel little forward and pull it toward you. (Image 1 of 2)
After removing the screw nuts or unlocking the clips, press the side panel little forward and pull it toward you. (Image 2 of 2)
Locate the battery of your vehicle.
With the help of multi-meter (Adjust voltmeter to DC volts - 20 Volts range) and check the voltage at battery which should be around 12 Volt. If the voltage drops below 9.5 volts, the battery has very low capacity and should be replaced.
If the voltage is less than above mentioned step or if there is white powder deposition, remove two nuts with the help of spanner, which are helping to fix both terminal or connector and disconnect the terminals from battery
If there is any deposition or rusting has happened at the terminals or connectors, clean the terminals by cloth or metallic polish paper.
If you have cleaned the terminals or connectors by using polish paper, clean the terminals by cloth to remove any small dust particles.
Also follow the same previous steps to clean the terminal of battery.
Put the connector or terminal cables back on the battery (please pay extra attention while reconnecting the terminal ends) The positive and negative terminal cables should connect respective battery terminals.
Tighten the terminal nuts by slowly rotating the nuts in clockwise direction.
Re-install the side cover and tighten all the screws properly.
If there is no improvement in the response of battery, or if you're facing any similar with your vehicle, or for bike service, contact your next door certified Doers mechanic for door step service.